Dr. Corvette says that if you are not able to wait for the long delays in producing a jig assembled front end for your 1965 or 1966 Corvette, then this may be an excellent option for you. All of the part numbers that appear in this category are the exact press molded parts that make up a jig assembled press molded front end. The only difference is, they haven't been glued together yet. They can very easily be assembled on your Corvette and with a little bit of care and skill they will fit your Corvette as good or better than a jig assembled front end. The only difference will be in the way the filler squeezes out from behind the panels. Again with a little care and skill a very acceptable outcome can be achieved. These parts normally take around 3 to 4 weeks to produce compared to 16 weeks to produce a jig assemble front end. - Call or email today for details.
